Pre-made templates made ​​masts, scheduled for a surfer center line, and beneath the other - along the sides. The transverse ribs placed in the cargo area and shvertovogo well. The shell may also be vykleit daggerboard in the matrix and, in the construction foam filling. However, the rules allowed to use the race and daggerboard timber. Fin light is easily obtained by casting into the soil, for example aluminum alloy, followed by finish machining. Strengthen it with screws to the body is not necessary: ​​a pair of strips of masking tape on the track provides a secure fit in the back pocket. Hinged mast steps we recommend you use a serial surfer of our "Mustang", and a metal cup stepsa priformovyvaetsya directly to the deck, still in the process vykleyki shell. And glass matrix is regular nut stuck together. As a binder for the construction of the surfer better is the use of polyester resin PN-609-21M. In a enclosure will take about 10 kg. You must also store approximately 15 m2 of glass and about 5 m 2 of glass fiber. Before the array, to a pressure quay two longitudinal wood beams 40 mm X130 - Power and ten transverse reinforcements - finer - of wood or rigid foam. After the body paste, drying and extraction must be drilled in the drain hole reverse. It is also used for quality control - to check for leaks surfer. Methods of test is simple: the camera is connected to the inflated rubber tube to the housing iomntsyu ball through the hole, and covered with a tight junction, such as clay. The chamber pressure should not fall out during the day. Otherwise, the air leakage measured using a solution of soap or the audience. After the test is repeated repair